static var compensator
static var compensator
[′stad·ik ′vär ‚käm·pən‚sād·ər]Static var compensator
A thyristor-controlled (hence static) generator of reactive power, either lagging or leading, or both. The word var stands for volt ampere reactive, or reactive power. The device is also called a static reactive compensator.
Need for reactive compensation
Reactive power is the product of voltage times current where the voltage and current are 90° out of phase with one another. Thus, reactive power flows one way for one-quarter of a cycle, the other way for the next quarter of a cycle, and so on (in contrast to the real power, or active power, which flows in one direction only). This back- and-forth flow results in no net power being delivered by the generator to the load. However, current associated with reactive power does flow through the conductor and creates extra losses. See Alternating current, Electric power measurement
Most loads draw lagging reactive power, which causes electric power system voltage to sag. On the other hand, under light loads, the capacitance of high-voltage lines can create excessive leading reactive power, causing the voltage at some locations to rise above the nominal value. Finally, it is prudent to keep reactive power flows to a minimum in order to allow the lines to carry more active power.
Mechanical versus static compensation
Utilities frequently install capacitors connected from line to ground to compensate for lagging reactive power and reactors connected from line to ground to compensate for leading reactive power. These reactors and capacitors are switched in and out with mechanical switches based on the level of line loading as it varies throughout the day. However, frequent operation of these mechanical switches may reduce their reliability. See Capacitor, Reactor (electricity)
It is desirable to have a controllable source of reactive power (leading or lagging); and the static var compensator, controlled with static switches, called thyristors, for higher reliability, fulfills this function. It is more expensive than mechanically switched capacitors and reactors (due to the cost of thyristor valves and associated equipment), and hence its use is based on an economic trade-off of benefits versus cost. See Semiconductor rectifier